go for it!!!  i put 33's on when most people said they wouldn't fit so of couse, fit 35's where most people think they don't fit!  just take the wheel off and take a big hammer and pound anything inside the fender that might hit the tire over so the tire doesn't get cut up.  there is a seam in the front that needs pounded over.  you also might need to cut the lower part of the fenders off.  kinda hard to explain but like the part of the fender that is rocker panel also.  i cut the crap outta that part too.  and you can cut a lot in the back but u just gotta take hammer to it when your done to pound the inner fender out to make contact with the outter fender. 

ok cool, i gotta find them in my pile o' junk.  i can't garenttee that the TRE's are good on this either as i've never had it on a truck.  i'll look when i get home later this week, probably friday or saturday cause during the week i plan on trading my rear 60 for a 14 bolt and then shaving the crap outta the 14 bolt.  when i'm done its gonna have the clearance of a dana 44 but the strength of a 14 bolt    (did you guys know there is no :drool: smiley here?  i just treid to use it and it didn't work...)