|
STICKY:
Tech Articles and Install Directions
(Preview)
GLXJ has a vast amount of tech articles, install directions, factory service manuals, and more to download free of charge. You can visit the tech page by visiting the link found here; http://www.greatlakesxj.com/tech.html If you have something that is not listed, please email it to us at tech@gre...
|
LEAD_NOT_FOLLOW
|
2
|
17057
|
|
|
|
|
STICKY:
Comanche Stock Specs
(Preview)
Common Design
All MJs were built as a full unibody design with the body and frame rails tied/welded together as one piece and cannot be removed, however, the rear is a fully boxed frame with the bed bolted to it, making the bed removable. All MJs have solid axles front and rear. The suspensi...
|
LEAD_NOT_FOLLOW
|
1
|
6654
|
|
|
|
|
STICKY:
84-01 Technical Service Bulletin's for 6 Cylinder Engines
(Preview)
1984 Jeep Truck Cherokee (No listing for 2wd or 4wd, just one title.)
http://www.alldata.com/TSB/04/840410cL.html
1985 Jeep Truck Cherokee 2WD
http://www.alldata.com/TSB/04/850416cL.html
1985 Jeep Truck Cherokee 4WD
[url]http://www.alldata.c...
|
LEAD_NOT_FOLLOW
|
1
|
9858
|
|
|
|
|
STICKY:
Cherokee Stock Specs
(Preview)
Common Design
All XJs were built as a "Unibody" design with the body and frame rails tied together as one piece as opposed to a body on frame design. All XJs have solid axles front and rear. The suspension is coils/leaf springs. All XJs came with disc/drums brakes.
Dimensions...
|
LEAD_NOT_FOLLOW
|
1
|
8141
|
|
|
|
|
STICKY:
Support this Club by Joining Today!
(Preview)
Just a friendly reminder to encourage you to becoming a supporting member.
This club, website, and forum is supported by our members.
What are the benefits of joining GLXJ?
Through your individual membership in GLXJ you will be able to network with other club members t...
|
LEAD_NOT_FOLLOW
|
0
|
5496
|
|
|
|
tranfercase question
(Preview)
i bought a np231j out of a 99 cherokee year ago. thought i could use it as a spare. can i use it in place of the np231j in my 95?
|
jimb
|
0
|
4520
|
|
|
|
|
xj wont start
(Preview)
I just picked up a 93 xj. the guy i bought it from smashed the gas tank on a rock at bundy, so he swapped in a fuel cell and an in-line electric fuel pump and now it wont start. I am getting fuel up to the fuel rail and I am getting spark to the plugs, but wont start. was wondering if anybody could give me some advis...
|
whitvan
|
6
|
4076
|
|
|
|
|
A/C locked up, need info on a/c pully delete/bypass adapter
(Preview)
just like the heading says, my a/c pully bearing locked up and engine won't run without squealing like a banshee!! i almost never use the a/c, so i'd rather just delete it from the equation. it's a 2001. i've read some other places that there is a bypass kit to do so, but i want to make sure this is the way...
|
dstaub
|
11
|
6629
|
|
|
|
|
how much for my comanche rocker panels/cab coners?
(Preview)
like the title said how much? when i bought my comanche 3 years ago. some decent rockers and cab corners came with my truck. they where cut from a to totaled out 2wd and never got installed on my truck. I'm not going to use them and I'm thinking about selling them. i did the magnet test and they seem to be all s...
|
jimb
|
2
|
5621
|
|
|
|
|
Sheared off motor mount bolts
(Preview)
I have a 94 xj sport that sheared off the motor mount bolts that go into the block. I know how too fix it, hate easy outs lol, but how would I beef up that area? Would grade 8 bolts fix it?
|
Seddie
|
3
|
4629
|
|
|
|
|
Deflators...
(Preview)
Me being me, I want to buy "Made in USA". Like Chinese? Take a drive through a once prosperous American city such as Detroit and you'll see the abandoned factories, abandoned (if not burnt down) neighborhoods, and those who remain. One of the reasons for such decay is the lack of jobs. W...
|
ChevelleSSLS6
|
2
|
4733
|
|
|
|
|
Doors
(Preview)
Will the doors on a two Cherokee fit and work on a Comanchee? If so what years inter-change? Thank you.
|
setterman
|
3
|
3549
|
|
|
|
|
rear spoiler/air deflector/thing-a-ma-jiggy
(Preview)
so i get really annoyed with dust, rain, snow, etc whipping down from the roof and onto the back window... as i'm sure you all do as well. has anyone come up with a solution to this annoyance??? i'm not having much luck finding anything online yet. i did find this style http://www.jeepforum.com/for...
|
dstaub
|
10
|
8858
|
|
|
|
|
comanche frame question
(Preview)
im looking at premade xj cherokee main frame stiffeners for my comanche. i have bad spots on my frame and i thought maybe these would make an easy way to fix/ reinforce the frame. my question is how far back are they the same? has any one done this?
|
jimb
|
2
|
5293
|
|
|
|
|
Flat Towing w/Front Locker
(Preview)
As many of you know we often Flat Tow the MJ when we go wheeling. This has worked great for us in the past for the most part and we'll most likely continue to go this route. I have been itching to go out and wheel a bit more and want to do a few more things to my MJ before I go out again. The biggest thing is install t...
|
LEAD_NOT_FOLLOW
|
5
|
7836
|
|
|
|
|
Changing fuel injection to a carberated set up?
(Preview)
I have a 87 XJ Pioneer with the 4.0 fuel injected engine that has some wiring issues and was wondering if I could just eliminate all the wiring by changing over to a carb set up. I know it would require a different intake a carb and a MSD like box. Will I need a different distributer as well? Will i have an...
|
Seddie
|
5
|
4336
|
|
|
|
|
master cylinder upgrade
(Preview)
My MJ sat on the sidelines most of the summer with fuel issues. As I now have them resolved and it runs good as new, I hop in to drive it around when my brake pedal goes right to the floor. My fluid is full and I dont appear to have any leaks so I have to believe that if my drums are not siezed, my seals went...
|
Matt D
|
2
|
3995
|
|
|
|
|
Leaf Spring Recommendations
(Preview)
I am in the market for new leaf springs. Any recommendations would be great! I currently have the 4.5" Rusty's leaf spring, but need to replace them for various reasons. I am looking to go a little bigger, maybe a 5" or a 5.5". I have read so many forums and reviews, but I need more fro...
|
xjbabe
|
7
|
7209
|
|
|
|
|
1995 jeep
(Preview)
I would to know if can remove my left and right axle with the u-joint assmenbly. and replace it with new cv-joint assy axle. please help. in desspret need of help. and if it can be done what else will I need to know before I do the job. Thank for your help out there in jeep land. sal
|
Spanky
|
2
|
4759
|
|
|
|
|
POWER DRAIN
(Preview)
Been chasing a power drain for a few weeks now. Mechanic has been unable to run it down. We did disconnect the rear power lock actuator which was shorting and cycling on its own. But the current drain is still there. The battery is new, load tests say it and alternator are okay. I'm at a loss, I have che...
|
docspanky
|
5
|
6162
|
|
|
|
|
Wiring issue on 87 xj
(Preview)
I'm new too the forum and newer to the joys of off roading a xj. My 87 had a little incident where the main engine harness grounded out and melted the thing together. Am i doomed to use a junkyard find o is there a simplified wiring harness i could make up. It is strictly a trail toy will never see the road so ju...
|
Seddie
|
0
|
3347
|
|
|
|
|
Power Seats '94 XJ
(Preview)
I have power seats in my '94 Cherokee Limited and both seat gearboxes have suffered the same problem, the nylon frame and bearing blocks have cracked and don't work. They are way too difficult to fabricate and I wondered if anyone has had similar problems and been able to fix them. The seat drive was cha...
|
ingin
|
2
|
5723
|
|
|
|
|
Thermal fan
(Preview)
My thermal fan is quite stiff to turn when cold, but at operating temperature, it spins very easily ie. there is virtually no resistance when hot. I thought it should be the opposite, easy to turn when cold (spins) and when hot should be resistive or stiff to turn. Can anyone advise if I am correct . Tha...
|
ingin
|
2
|
3022
|
|
|
|
|
Anyone else have a rare XJ?
(Preview)
I am posting this for alex673 I have a 1995 XJ Classic with "Limited" trim and decals - woodgrain dash, leather, power everything, Limited alloys with Classic centre caps, 4.0L HO, AW4 Auto, NP242 Transfer case... The one thing I am surprised at, is that for a '95, it has no high mount brake l...
|
aci4369
|
11
|
7480
|
|
|
|
|
Temp sensor for 1994 XJ
(Preview)
Can any one advise how best to test the coolant tempature sensor ( the one in the thermostat housing). I am not sure that my aux electric fan comes on when the temp reaches a critical level and with an Australian summer on its way, I would like to get it right asap. I can read the schematics ok, but when the le...
|
ingin
|
7
|
4754
|
|
|
|
|
Hello
(Preview)
I picked up '99 XJ about 9 months ago, and i today i am finally able to start driving it. Today i got it insured, and will be able to hit the road again! Just wanted to see if there is anyone in the Lapeer area thats on here. I plan on doing the usual list of things over time, but i need brakes, U joint, CV join...
|
Chris
|
2
|
3533
|
|
|
|
|
97 XJ doesn't latch ASD relay
(Preview)
My '97 UK Spec 4.0 petrol won't start any more. It cranks over OK but the ASD relay doesn't get held over - which means no spark and no fuel. When the ignition is switched on the ASD relay clicks over for 2 seconds, then switches off again. I have of course substituted the relay. There are no fault codes. I ha...
|
a_q
|
1
|
3385
|
|
|
|
|
lower short arms for the comanche
(Preview)
http://claytonoffroad.com/product_info.php/cPath/18_69/products_id/80
|
jimb
|
1
|
4495
|
|
|
|
|
Shackle Bolts...
(Preview)
So my buddy Jim (best friend, and owner of a Cherokee and a Comanche) left the following on my facebook page tonight. I haven't bothered the parts guy yet (I see him enough as it is), but just wondering if anyone knows the specs of the shackle bolts, or where he could find new ones that are the same specs as...
|
ChevelleSSLS6
|
7
|
4329
|
|
|
|
|
Worn Track Bar Symptoms
(
1 2
)
(Preview)
After replacing my lower control arm bushings I took my 97 XJ for an alignment. The shop refused to do the alignment saying that there was too much play at the ball stud end of the track bar. What are the symptoms of a worn track bar? The XJ seems to handle OK, except for a little drifting under hard brakin...
|
weebur
|
15
|
13811
|
|
|
